A built-in oven that will not reach temperature is usually a failed element or a drifted thermostat — both common, both fixable. We test each zone and the fan so you are not left with an oven that bakes unevenly after the visit.

Induction hobs flash error codes for coil, fan and board faults; we read the code and verify it before condemning an expensive board. Plenty of "dead" hobs are a cooling-fan or sensor fault that costs a fraction of a new unit.

Gas hobs that click but will not light, or burn with a yellow flame, are a safety matter as much as a repair. We clean and test the igniters and jets and check the gas path so your kitchen is safe to use again.

What’s included

• Heat and element test across all zones
• Igniter and gas-safety check (gas hobs)
• Induction error-code diagnosis
• Price confirmed before parts go in
• 90-day workmanship cover on the repair

Common add-ons

• Element / igniter replacement
• Thermostat recalibration
• Induction coil swap

Good for: Built-in ovens, induction and gas hobs, and freestanding cookers.
Turnaround: Element, igniter and sensor jobs close same visit.